Miller Specialty Tool Kit # 9967 Box 1 of 2

Component photos courtesy Miller Tool Company

Read the IMPORTANT INFORMATION in the right sidebar.

# 8912 Bearing Remover

This special tool is used with the 8915 Brace to remove the Input Shaft Bearing from the housing of G288 manual transaxles. to current.

# 8913 Bearing Cup Remover

This special tool is used with the 8915 Brace to remove the Differential Bearing and Output Shaft Bearing Cups from the Housing of G288 Manual Transaxles. To current

# 9684 SEal Installer

This special tool is used with the C-4171 Drive Handle to install the Power Transfer Unit Pinion Flange Seal in 2005 Pacifica vehicles equipped with All Wheel Drive

# 9721 Staking Tool

This special tool is used to stake the Transfer Gear Nut (Underdrive Compounder Side) after installation and torquing on the 62TE transaxle.

# 9723 Bearing Installer

This special tool is used with an Arbor press to install the Small Pinion Bearing onto the Shaft in 62TE transaxles.

# 9725 Spring Compressor

Use this special tool with an Arbor press to compress the Low Clutch Spring Retainer for Snap Ring Removal and Installation in the 62TE transaxle.

# 9729 Bearing Cup Installer

This special tool is used with the C-4171 Drive Handle to install the Large Pinion Bearing Cup in the 62TE transaxle

# 9730 Bearing Cup Installer

This special tool is used with the C-4171 Drive Handle to install the Small Pinion Bearing Cup in the 62TE transaxle

# 9735 Torque Turning Fixture

Use this special tool with a Torque Wrench to check Differential Turning Torque in 62TE transaxles.

# 9952 Bearing Cup Installer

This special tool is used with the C-4171 Drive Handle to install the Compounder Bearing Cup during service procedures on the 62TE transaxle

# C-4995-2 Collet

Use this special collet with the C-4995-A tool to check for proper Rotational Torque in the Differential Assembly in 62TE transaxle