Miller Specialty Tool Kit # 9870
Product ID #05-200-057
Tools to properly service CVT Transmissions during service or overhaul procedures.
Manufacturer: Miller / OTC / Chrysler
Components: 9858, 9871,9877, 9876, C-293-40, 9919, 9875
meets OSHA training; best hybrid diagnostics available
Misfire Code and Fuel Monitor Diagnostics
learrn the professional shortcuts and eliminate comebacks
Component photos courtesy Miller Tool Company
Read the IMPORTANT INFORMATION in the right sidebar.
#9958 Seal Installer
This special tool is used with the C-4171 Drive Handle to install the Torque Converter Seal to its proper depth in CVT Transmissions.
# 9971 Seal Installer
This special tool is used to install the Output Shaft Seal ( Belt Side) to its proper depth in CVT Transmissions.
# 9875 Compressor
This special tool is used in conjunction with the 5058A Spring Compressor to compress the Reverse Piston for Snap Ring removal in the CVT Transmission during service procedures.
# 9877 Seal Installer
This special tool is used to install the Differential Output Shaft Seal ( Torque Converter Side) to its proper depth in the CVT Transmission.
# 9919 Bearing Installer
This special tool is used with the C-4171 Drive Handle to install the Large Differential Bearing in vehicles equipped with CVT Transmissions and 4 Wheel Drive.
# C-293-40 Puller Block Set
Used to remove the Pinion Bearing from the 194FIA , 194RBI, 198RBI, and 216FBI axles. Used with C-293-PA Puller Press. Note: Two additional Adapter Blocks , C-293-40-1, must be used with the C-293-40 Block Set (6 blocks are required) and the C-293-PA Puller Press to remove the Small Differential Carrier Bearings from 2 Wheel Drive CVT Transmissions. C-293-40 is 2 blocks
IMPORTANT INFORMATION
Our OEM tool distributors have granted us access to some of their repossessed tools inventories. These are the same idential tools supplied to the captive manufacturer's dealer. Since they are mostly repossessed tools do expect cosmetic damage (eg: minor wear, surface conditions). You will be rewarded with 30 to 60 percent off retail prices, most kits include the carry / storage case.
Some of these kits are rather heavy, so the shipping charges (48 states, USA only) will be co-oped by the distributor with a single flat rate shipping price to you on each kit.
For shipments outside of the 48 states USA contact us for accurate co-oped shipping charges.
-
Miller Tool 6549
-
Miller Tool 8266A
-
Miller Tool 8392
-
Miller Tool 8666CC
-
Miller Tool 9518-5
-
Miller Tool 9967 1-2
-
Miller Tool 9967 2-2
-
Miller Tool 9978
-
Miller Tool C-3887-B
