Miller Specialty Tool Kit # 8712CC Box 1 of 2

Component photos courtesy Miller Tool Company

Read the IMPORTANT INFORMATION in the right sidebar.

# 8379 Wedge Locking Tool

This special tool locks the Timing Chains against the hydraulic tensioners to prevent tensioner ratcheting and piston extension during service procedures on 3.7 Liter Engines. Services 2003 to current model year.

# 8426 Valve Spring Compressor

Use this special valve spring compressor during service procedures on 3.7 Liter Engines with the head on or off the engine

# 8428A Camshaft Holder

Usethis special tool on the 2008 3.7 and 4.7 Liter engines to hold the Camshaft during Camshaft and Timing Chain service procedures. NOTE: This tool will supercede the 8428 tool and will also work on the early applications.

# 8429 Secondary Camshaft Chain older

This special tool is used to hold the Secondary Camshaft Chains in place on the idler sprocket during timing chain replacement in 3.7 Liter Engines. Services 2003 to current model year.

# 8641 Remover and Installer

This special tool is used to remove and install the Counter Balance Shaft in the 3.7 Liter Engines. Services 2003 to current model year.

# 8692 Bearing Cup Installer

Use this special tool with the C-4171 Drive Handle to install the Front Pinion Bearing Cup in Dodge Ram trucks equipped with C205F axles. Services 2003 to current model year.

# 8693 Bearing Cup Installer

Use this special tool with the C-4171 Drive Handle to install the Rear Pinion Bearing Cup in Dodge Ram trucks equipped with C205F axles. This tool is also used to remove the Input Shaft Bearing in vehicles equipped with the Nv140 Transfer Case. Services 2003 to current model year.

# 8694 Seal Installer

This special Seal Installer is used to install the Axle Seals in Dodge Ram trucks equipped with C205F Front Axles. Services 2003 to current model year.

# 8695 Seal Installer

Use this special tool with the C-4171 Drive Handle to install the Pinion Seal in Dodge Ram trucks equipped with C205F Front Axles. Services 2003 to current model year.

# 8698 Ball Joint Remover and Installer

This tool is used with the C-4212F Press to remove the Lower Ball Joint from the Control Arm in Dodge Ram Trucks. Services 2003 to current model year.